Burst Pipe Water Damage
A failed supply line is shut off, the water is pulled out of floors and wall cavities, and the structure is dried under daily readings.
A Haw River flood that climbed from two feet to over thirty in a single day, a supply line that split under a kitchen sink, a crawl space that stayed wet all spring, or a storm that drove rain past the flashing. Call (833) 490-5225 at any hour. A crew is dispatched as fast as one is available, and the emergency stage is explained before equipment starts.
Fastest: call (833) 490-5225. Or send this and we call you back.
Local weather drives activity here: heat, humidity and rain change what shows up week to week.
Burlington Water Damage Restoration answers water damage calls for Burlington, Alamance County and the towns around it, 24/7. A crew is dispatched as fast as one is available. Standing water comes out first, then the wet structure is dried to measured readings, and dated photos and logs are kept for the homeowner and the insurer.
Calls in Burlington tend to start in one of four places: the Haw River or a creek that left its banks, a supply or drain line that failed inside an older house, a crawl space that took on ground moisture through a wet season, or a roof and window opening that let rain in during a storm. The first steps differ by source, but the order never does: stop the water, take it out, then dry the structure until the readings say it is dry.
While you wait for a crew, close the main valve if the water is coming from a pipe, keep the power off in wet rooms, stay out of standing water and photograph the damage from the dry side of the room. Those details are the first thing the crew asks about, and they shorten the first visit.
Pick a service for symptoms, process and typical cost, or call and describe what you hear and see.
A failed supply line is shut off, the water is pulled out of floors and wall cavities, and the structure is dried under daily readings.
River water is removed, contaminated porous materials are taken out, surfaces are cleaned, and what remains is dried and rechecked.
After a remnant system, buildings are triaged by how wet and how contaminated they are, then pumped, stripped where needed and dried.
Depth is pumped out, the remainder is extracted from flooring and cavities, and sediment is cleared so that drying can begin.
Century-old village housing is dried with its own materials in mind: timber framing, nogged walls, lath and plaster, and plank subfloors over piers.
Water is pumped from under the house, ruined insulation and barrier are removed, and the joists and subfloor are dried to readings.
Water that enters through basement walls or floor joints is traced to its path, pulled out, and dried under readings before anything is closed up.
Waste water that has come back up a drain is removed under protection, the porous materials it reached are taken out, and the room is dried and checked.
Rain that has come through a damaged roof is traced down through the attic and ceiling, the wet insulation and board are removed, and the framing is dried.
Rain driven in by wind is traced through the walls and openings it entered, the wet materials are removed, and the structure is dried under readings.
A tank or fitting that lets go is isolated, the water is removed from the floor and the wall base, and the closet or utility room is dried under readings.
A leaking washer, dishwasher or refrigerator line is shut off, the water is pulled from beneath and behind the unit, and the floor and cabinet base are dried.
A stained or sagging ceiling is opened in a controlled place, the wet insulation and board come out, and the framing above is dried before any new board goes up.
Wet framing, subfloor and wall cavities are dried with air movement and dehumidification, and the work continues until readings match dry areas of the house.
Mold that follows a water event grows on materials that stayed wet, so the work is to find the damp areas, remove what cannot be dried, and confirm the readings.
A leak that is out of sight is located by measuring the water and the moisture, narrowing the search, and opening only the material needed to reach the source.
Water in an apartment or rental home is traced to its source, the wet materials are removed and dried, and the record is kept for the owner, the tenant and the insurer.
Large commercial and older mill structures are measured zone by zone, because timber, masonry and wide floor plans hold water in ways a small house does not.
Phones are answered 24/7, holidays included, so a call at 3 a.m. about water spreading across a kitchen floor reaches a person who can walk you through the first steps.
Standing water is pumped or vacuumed out first. Air movers and dehumidifiers only work on moisture that is still in the materials, not on a flooded floor.
Equipment stays in place until moisture readings for the wood, drywall and subfloor reach their dry targets, not for a fixed number of days.
Water from the Haw River, a creek or a street that flooded is handled with its own steps, and so is sewage that backed up through a drain.
Dated photos, moisture logs and a removal list are kept as the work goes, so you can hand the facts to your insurer without rebuilding them later.
The emergency stage is explained and approved before equipment starts, and each addition is described to you before it is done.
If a pipe or appliance is the source, shut off the main and stay clear of wet outlets. Then call the number at the top of the page. The first questions are where the water is coming from, whether it is still coming and which rooms are wet.
Do not wade into water near an outlet, a panel or the furnace. Keep children and pets out, and wait for the crew if the power to the area cannot be confirmed off.
A technician walks the wet rooms, marks the high-water line and takes moisture readings. The walkthrough decides whether the water is clean, flood or sewage, which decides what can be saved.
Standing water goes first. Materials that cannot be dried in place come out with your approval. Drying runs to measured targets, and readings and photos are handed over at each visit.
Shut off the main water valve if the source is a pipe, turn off power to wet rooms if you can reach the panel without standing in water, move valuables up, and photograph the damage. Then call. A phone call before cleanup starts lets the crew tell you what to keep and what to leave.
A split supply line, a failed water heater tank or a dishwasher hose can put a lot of water on a floor in a short time. Closing the main is the one step that stops the volume. Many houses in the city have the main valve near the meter at the street or along an outside wall, so find yours before you need it and note which way it turns.
Flood water is different because it comes from outside. When the Haw River rises, the water arrives carrying silt and whatever the street or yard held, and it should be treated as contaminated. Do not mop it up or run a household vacuum through it, and let the crew decide what comes out.
The city sits in the Piedmont of Alamance County, with the Haw River running through the county and its towns. Older housing, river flooding and storms that move inland from the coast all bring different losses, so a single call can come from any of several sources.
Burlington began as Company Shops, the repair yard the railroad set up in 1855, and much of its older housing was built around that rail life. National Register documentation describes many privately built neighborhoods from the 1900s through the 1920s as little changed, centered on Davis and Mebane streets. Houses of that age carry old supply lines, older drains and framing that holds water longer than newer construction does.
The river is the other part of the record. Hurricane Fran in September 1996 pushed the Haw River at Haw River to a crest of 32.83 feet. In July 2025 the remnants of Tropical Storm Chantal brought it to 32.5 feet, the second-highest crest on record there, and water near Burlington rose from two feet to 32.5 feet in about thirteen hours. That is why river water is part of the local response, not an exception to it.
Older houses in the city often have supply lines and drains that have aged out of their service life, and their wood framing can hold moisture in walls and under floors long after the surface looks dry. Heavy timber in mill-era houses dries more slowly than modern framing.
Glencoe Cotton Mill and its village were built between 1880 and 1882 on 105 acres by the Holt family, with houses of heavy-timber framing and brick nogging. The village is a National Register historic district, and a statewide preservation nonprofit bought it in 1997. Mill-era framing is strong, but it is thick, and water that enters it can stay in the timber for much longer than it does in a thin modern wall.
A leak in an older house is often found late, because the water travels along a joist or down a stud before it shows on a ceiling. Cast iron drains, galvanized supply lines and old tub connections are common reasons for slow losses. A crew checks the wall cavities and the subfloor, not only the room that shows the stain, because the damage that matters is usually the damage behind the finish.
Keep dated photographs from the dry side of each room, a written list of damaged items, and every invoice and moisture reading from the crew. Those records let you describe the loss clearly, and they are the evidence a claims adjuster asks for first.
Photograph the water line on the walls, the floor covering before it is moved, and any item that is damaged. Take a wide shot and a close one of each, and keep the original files on a device you can reach later. A written list of what was lost, with approximate age and where it was kept, is worth more than a memory of it after a week of cleanup.
Insurance rules vary, and this page does not describe what any policy covers. What it can say is that a homeowners policy usually responds differently to a sudden break than to a seep, and that flood and sewer backup are often handled under separate terms. The North Carolina Department of Insurance is the state office that takes consumer complaints about how claims are handled.
ZIP 27215
ZIP 27216
ZIP 27217
ZIP 27220
ZIP 27201
ZIP 27244
ZIP 27253
ZIP 27258
ZIP 27359
ZIP 27249
ZIP 27377
ZIP 27342
ZIP 27202
ZIP 27244
ZIP 27340
ZIP 27349
ZIP 27302
ZIP 27283
ZIP 27301
ZIP 27298
ZIP
Burlington, NC · 26 km service radiusCall (833) 490-5225
We also cover many smaller communities across Alamance County. Check your ZIP.
If it's an emergency, call now. For non-urgent water damage restoration, send the form and we'll call you back.
The size of a water damage scope in Burlington follows four measurable things: how much floor area got wet, how far moisture climbed into walls and framing, how many days it sat there, and whether the water was clean supply water or came off the ground.
Keep people out of the water, kill the power to any flooded room from a dry position, and photograph the standing water and its height on each wall before a single item is lifted.
A tropical system that has lost its wind over land still carries an enormous amount of rain, and in Alamance County that rain lands on a watershed that funnels into the Haw.
Phones are answered 24/7, holidays included. A crew is dispatched as fast as one is available, and no arrival time is promised, because a phone line cannot guarantee one. The call itself starts the safety steps right away, including the main valve and the power to wet rooms.
Move anything valuable out from under the wet spot, place a container to catch the drip if it is safe to do so, and turn off the power to the lights and outlets in that room if you can reach the panel dry. Photograph the stain and the water as it stands. Then call so the source can be traced.
Yes. Shops, offices and mill-type buildings in Burlington can have the same sources as houses, plus larger floor areas and more equipment. Describe the building, its use and the rooms affected when you call, and the crew will explain the emergency stage before work starts.
The technician checks the water and its source on the walkthrough, and that check decides how the water is handled. Water that came from a drain or a toilet is treated as sewage. Do not assume the water is clean because it looks clear, and do not touch it without gloves and protection.
Wood, drywall and insulation can stay wet behind a surface that already looks dry. Drying is measured with readings rather than judged by eye, so the crew keeps equipment in place until the materials reach their targets. Those readings are shared with you at each visit.
Yes. Ask the person on the phone to name the company that will attend and the technician's name, and ask what it holds for each stage of the work. The answers are yours to check, and the About page explains how the call is handed on.